How to install self-adhesive window picture – some tips

How to install cocky adhesive window moving-picture show and what you need to know. How to do it correctly and what tool is needed for this? Everything is quite elementary, but you need to know the engineering science and follow the social club of execution.


Every bit with all films, a special tool must be used for cocky adhesive window picture.

  • Sprayer for spraying liquid
  • Rubber wiper for cleaning the glass
  • Blade for mechanical glass cleaning (optional)
  • Duster for smoothing the motion picture and squeezing the mounting mortar from under the motion picture
  • Lint-gratuitous wipes
  • Knife with a sparse blade for cutting the moving-picture show along the edge

You tin get free, full window film tools from the states for quality work.

Watch this Video


Attention!! Be sure to use an associates solution. Yes, the motion-picture show has an agglutinative layer, but the mounting solution allows you to distribute the picture evenly over the drinking glass without air bubbles

How to install (stride by stride) self adhesive window motion picture

  1. The unabridged instrument must exist prepared.
  2. Preparing the flick. Information technology is necessary to cutting the flick 2-3 centimeters larger than the glass. Or gild a film of the finished size window flick cut to size.
  3. Set up the installation solution. Cascade clean water into the sprayer. Add together mounting solution at the rate of 2-3 drops per ane liter of h2o.
  4. Wash the glass thoroughly. Spray over with mounting mortar and gradually go through with a blade. The blade removes mechanical impurities, adhering dirt, etc.
  5. Spray drinking glass once more. Wipe the frame near the drinking glass with napkins. We carefully pass the glass surface with a rubber wiper.
  6. Spray over with mounting mortar
  7. Gradually remove the protective liner from the film and fill in the mucilage layer
  8. Apply the pic to the glass. The film should float a little - this will allow it to exist distributed without folds and air. If the pic doesn't float but is STICKED, information technology means a trivial added mounting solution.
  9. On height of the film, spray a thin layer of assembly mortar. This will allow the window motion picture squeegee (rakel) to slide over the film.
  10. Carefully gradually we become through the unabridged surface of the film. With gradual light movements we drive the solution out from under the movie.
  11. If necessary, trim excess window film forth the edge of the glass with a pocketknife.
  12. Spray over again with assembly solution. Squeeze out the solution again, just with stronger movements.
  13. Remove moisture from the edges of the motion-picture show with a napkin.
  14. If necessary, after two to three hours, you lot tin gently tighten the edges of the flick.

This installation principle can exist used for any blazon of window flick. For example

  • window frosting film
  • window mirror moving picture
  • 1 way window picture show
  • privacy picture

In that location is some departure in the window glass protection film, a less concentrated assembly solution is used and the disassembly of the glass structure is required (in some cases).